Military AI Works

I have finally started learning how to use ADE and all of its functions etc... I have tryed to add an ILS to it and as far as I was concerned I was doing it correctly but then I get this when I went to compile it. Can anyone help please


Kind Regards
Dale

Dale,

what does the fault finder say?

Mark

Nothing to do with an ILS

Have you filled in the properties box fully...check the ICAO code is filled in.

PM me the XML or ADE project file and I will take a look for you Dale.

Mark

Have you considered asking the experts at the ADE forum?

I seem to remember this comes up on a regular basis there, or at least used to until it had been answere for the umpteenth time.

I have had this error before, its when your missing a part of the ILS (at both ends) send me your project and can see.