Page 1 of 1

Swiss/Austrian PC6

Posted: 01 Dec 2016, 10:58
by ws.jones27
Hi, I have just found a wierd problem with both packages of Swiss/Austrian PC6 on my sim' they have changed into textureless Chance Vought F4U Corsairs and using the call-signs of Pilatus PC6. I deleted both packages and reinstalled Ray Parkers packages once again but still come up with the same problem but this time with an extra glitch- it removed the PC7s at Zeltwig. Finally I deleted completely both PC6 packages and reinstalled the Zeltwig , I am not trying to imply that there might be a virus on both Ray's packages but that is all I can think of - I would like add that I have never downloaded or installed a F4U Corsair . Anyone come across this kind of problem.
BJ

Re: Swiss/Austrian PC6

Posted: 01 Dec 2016, 12:00
by JohnTenn
BJ

Did you use a program to install the aircraft and paints?

John

Re: Swiss/Austrian PC6

Posted: 01 Dec 2016, 12:29
by hermit
The paints are Ray's but the model is from EDAviation. I installed the packages in 2012 but when I viewed the model in ACM it appeared as a Corsair. I emailed Ray who sent me his copy but that also appeared as a Corsair in ACM. So I deleted them without ever reviewing them in the sim (FS9).

Your post prompted me to take a look in ModelConverterX which I didn't have at the time and it appears as a PC6. How wierd?

The model.cfg points at pc6.mdl but the model folder also contains pc6.m00 and pc6f.mdl. Viewing pc6.m00 in MCX just errors but viewing pc6f.mdl appears as as a Corsair. So I deleted them from the folder to leave just pc6.mdl and now in ACM it no longer appears as Corsair but as a PC6. I know nothing about model naming but that is just strange.

I don't have time to check it in FS9 but it could be worth deleting these other 2 files to see what happens.

Re: Swiss/Austrian PC6

Posted: 01 Dec 2016, 15:26
by ws.jones27
Hi, just like to say thanks for the advice regarding the mdl and you were right it was the wrong one so all is now up and running with I might add without "phantom corsair F4Us flying about". The error with the mdl could well have been my fault due to the fact that a short while ago for some unknown reason I lost mdls on a number of aircraft and had to retype them again. Once again much appreciated.
BJ

Re: Swiss/Austrian PC6

Posted: 01 Dec 2016, 17:38
by f4nutter
I am not trying to imply that there might be a virus on both Ray's packages but that is all I can think of

how dare you suggest such a thing !!! :x :evil: :twisted: :D :roll:

Re: Swiss/Austrian PC6

Posted: 01 Dec 2016, 17:58
by ws.jones27
My most sincere apology Ray and hope you will forgive an old fool.
BJ

Re: Swiss/Austrian PC6

Posted: 01 Dec 2016, 18:27
by clickclickdoh
I for one am now actively trying to figure out a plot to secretly hide files in a project that will cause phantom WWII fighters to appear....

Doe anyone have a Scooby-Doo Doo glowing ghost effect?

Re: Swiss/Austrian PC6

Posted: 03 Dec 2016, 00:18
by f4nutter
i'm only messing with ya, no offence taken in any way
:)