Military AI Works

Downloaded & installed an Afghanistan scenery recently from Simviation.

However, if I'm sitting on the ground the runway does not appear - you can see the taxiways etc - just not the runway.
Once airborne the runway appears from the "far-end" and becomes a complete - as expected runway.
I've tried putting an apron polygon around the runway limits, but all I get is the polygon!!


Anyone any ideas?

Check to make sure that the runway altitude and the scenery altitude are the same. Usually this happens if the runway has been raised or lowered for some reason.

Hi Jim.

Have sent you an email with a small utility which should help.

Cheers guys...yep it was a mismatch of altitudes...all sorted now.

Many Thanks


Jim

Hi,

Would also appreciate the programme, have a similar problem at a couple of airports.

nigelc@imaginet.co.za.

Thanks

Nigel

Hello,

Can you share me this software too ?

Thanks a lot.

The file you are looking for is..jabbgl_134445.zip on AVSIM.

Jim