No turning props after converting FS9 model into P3Dv4
Posted: 16 Mar 2019, 18:07
Hi experts,
don't want to annoy you with requests of a C-160 Transall conversation. So I did some experiments by my own and now I want to annoy you with some AI-technical questions instead...
First of all, I am not familiar with aircraft converting in MCX, I only know this program halfway well for scenery design.
Okay.
I run Fernando Martinez C-160 through MCX and exported it into a P3Dv4 model. That seems to work fine, also the aircraft appear well in P3Dv4. But when they start taxiing, the two props don't rotate.
I got several "unknown BGL opcode 3 at position....." issues:
Each hint is much appreciate, watching some C-160 on several german air bases is a great change for some few days off designing
RAF Brüggen
.
(Work goes on next week, promised...)
don't want to annoy you with requests of a C-160 Transall conversation. So I did some experiments by my own and now I want to annoy you with some AI-technical questions instead...
First of all, I am not familiar with aircraft converting in MCX, I only know this program halfway well for scenery design.
Okay.
I run Fernando Martinez C-160 through MCX and exported it into a P3Dv4 model. That seems to work fine, also the aircraft appear well in P3Dv4. But when they start taxiing, the two props don't rotate.
I got several "unknown BGL opcode 3 at position....." issues:
Each hint is much appreciate, watching some C-160 on several german air bases is a great change for some few days off designing
RAF Brüggen
.(Work goes on next week, promised...)