Page 1 of 1
2pam afcad
Posted: 30 Oct 2007, 21:26
by rgr841
i just tried to install the drones for tyndall and homestead and when i run traffic tools it says there is no airport 2pam for the flightplans. how do i add this, do i need some lats and longs to add this to the airports list. thanks
Posted: 30 Oct 2007, 22:53
by KevinJarvis
I just used the long/lats from KPAM. Not sure if that was the right thing to do....???
KJ
Posted: 31 Oct 2007, 00:07
by BadPvtDan
You need an afcad for 2PAM. The coordinates will come from the lat and lon that are in the afcad.
Posted: 31 Oct 2007, 02:31
by rgr841
I downloaded and used the 2pam afcad by flyboy in his drone package, but when i open it there is no information to add to the airport list, if i'm doing this right.
Posted: 31 Oct 2007, 03:33
by BadPvtDan
That information can be gleaned from File|Properties in afcad.
2pam
Posted: 31 Oct 2007, 13:14
by lewis
Hi
I just changed the kpam to 2pam and it works fine. Make your 'airports" file as this:
2PAM,N30* 4.08',W85* 34.45',16
KHMN,N32* 51.03',W106* 6.32',4094
You should be seeing all those drones in Tyndall in no time.
Cheers, Lewis