Page 1 of 1
Cannon AFB Problem
Posted: 08 Jun 2008, 21:34
by djnocturnal
Does any one else have a problem with cannon afb? when i go there the runway disapears in parts. is it an elevation problem? does any one have the fix for it?
Posted: 09 Jun 2008, 04:04
by ronniegj
This problem at Cannon has been discussed before. I don't know if the issue was solved or not. If so, I'd sure like an AFCAD with the fix. If anyone has a fix, how about letting us know!
Ron
Posted: 09 Jun 2008, 05:57
by djnocturnal
yeah i searched another post where a minot and cannon afcad were shared but there was never any post as to how to correct it
CANNON AFB RUNWAY FIX
Posted: 06 Jul 2008, 23:45
by flyerkg
Has anyone tried putting a taxiway under the portion of RWY 31 and the overrun to RWY 4 where the runway texture disappears?
I remember reading a thread somewhere that explains how taxiways in AFCAD@ automatically flatten the surface under them. I put in a section that was 155ft wide and as long as the missing section of the runway and this seems to work fine for me. I don't have parking at Cannon yet so I don't have a full AFCAD project to upload. Good luck!
Keith