AFCAD design / updating
Posted: 01 Dec 2006, 10:17
Hi all,
following on from my previous question about scenery design, I was tweaking the Fairford AFCAD last night and came up against a rather large problem.
I've looked but failed to find any limit for the number of 'dots' (sorry can't remember correct term for them for the perimeter of a section of apron to have. I'm filling in a rather complex shaped area of grass as they have to fit around and concrete areas and all of a sudden I've reached a point whereby the dots I'm trying to move will not go from green to yellow to allow me to move them.
Does anyone know the maximum allowed per piece of apron or indeed whole AFCAD??
Thanks in advance,
Dave.
following on from my previous question about scenery design, I was tweaking the Fairford AFCAD last night and came up against a rather large problem.
I've looked but failed to find any limit for the number of 'dots' (sorry can't remember correct term for them for the perimeter of a section of apron to have. I'm filling in a rather complex shaped area of grass as they have to fit around and concrete areas and all of a sudden I've reached a point whereby the dots I'm trying to move will not go from green to yellow to allow me to move them.
Does anyone know the maximum allowed per piece of apron or indeed whole AFCAD??
Thanks in advance,
Dave.