Military AI Works

Post any and all support related comments for this package in this thread.

NOTE: Support for FSX users will not be offered in this thread. Instead FSX support can be had by posting questions in the MAIW Packages in FSX support thread located here.

So glad my babies are finally released guys

Just one thing though... my surname is PascAl, not PascUl....no big deal

PaSkull might be even more aggressive! Great job!

Psuls wrote:So glad my babies are finally released guys

Just one thing though... my surname is PascAl, not PascUl....no big deal

Yes of course sorry mate. Correcting it now.

Thank you MAIW!!! I have been looking foward to this release for a long time now.

Awesome release!

Can't wait to spot all those heavies!!!

Thanks to all involved!

I think it goes with out saying that we have been waiting for this one for a looooooooooooooooooooooooooonnnnnnnnnnnnnnnnnnng time

thank you MAIW

When I go to fly at Dover, the sim loads and starts me but then FS automatically closes with no error or anything. I went in and deleted all the "AF2 KDOV" files I could find from before this package, and re-installed it twice with the same error.

Suggestions?

It loads fine with me on a pretty virgin setup.

I just want to add my thanks to everyone else...its great to see more beasts roaming around the skies. Great work.

Good things come to those who wait.


At Joe W: Make sure you have all the required effects for the model. It uses FS9 default light effects and 3 custom made effects that come with the package. If you don't have even one of those effects installed, it might be causing your CTD. It shouldn't but I experienced something similar to this during testing.

Great job and I can finally retire my M. Stone flyable C-5's. Just wanted to check on something. After reading the readme and checking AFCADs, I found a rogue AF2_KMEM in my folder and quickly deleted it. I then fired up the sim and checked each C-5 base as a test. I finally got to MEM and noticed the C-5's were fine, along with other transit mil traffic, but my civilian side seemed to be lacking in flights with empty gates? No changes to traffic settings and I use WOA packages for the major airlines.

Awesome and long awaited package. I notice there is no UAFM afcad. Is it correct?

Giorgio

bismarck wrote:Awesome and long awaited package. I notice there is no UAFM afcad. Is it correct?

Giorgio

That is correct, it was taken out during beta testing, I plan to have it out eventually in one of the two remaining parts of the series

Thanks a lot.
...other two parts?.... nice to hear

To all that put the East AMC C-5 package together thank you for your work and brilliance!

At Joe W: Make sure you have all the required effects for the model. It uses FS9 default light effects and 3 custom made effects that come with the package. If you don't have even one of those effects installed, it might be causing your CTD. It shouldn't but I experienced something similar to this during testing.

Thanks Mike, I'll try that. I just wound up editing my own AFCAD to fit the package to get it to work. <<shrug>>

Ok, I got Dover to work as I said before. But now Stewart Intl (KSWF) is doing the same thing, crashing my sim. I went into the scenery folder and deleted everything I had related to that AFCAD/airfield, and re-installed the package in it's entirety. Same problem. Sim just minimizes and closes. Is there something "weird" with this airport that I should be looking elsewhere than my scenery folder?? I first noticed it when I did a flight from Syracuse-New York (JFK). As I approached the NYC (KSWF) area the game would crash, minimize and close. The only thing I've changed in my sim since it last worked 100% was the installation of this package, so I know it's isolated to somewhere with this. Please advise.