Military AI Works

Just like the tittle says. I have installed the 913th package that was put up on avsim by Aaron Hasse. What seems to be happening is that the C-130s show up for a few seconds, then they seem to fall to their right side and then proceed to fall nose first into the ground. I am not sure why that happens but it does Also another thing that is happening is that one of the 913th 130s would land, then a few mins later he would fall into the ground and then disappear. I have a custom afcad that flows better with the scenery i have there. I the three packages that are MAIW related are the Navy and Marine C-130s, Navy and Marine transports( C-9s and C-40s) and the Great Lakes package number 2 with the PA A-10s. Any help would be awesome. I will have links to pictures to help give a better visual reference to my problem.

Thanks

Carl

http://img406.imageshack.us/i/wdq.png/

http://img221.imageshack.us/i/grtg.png/

http://img218.imageshack.us/i/72049983.png/

http://img266.imageshack.us/i/wdw.png/

Carl I would start by disabling your custom scenery and using a different afcad file. Try that and they you should be able to narrow the problem down a little bit more.

mike
I tried to do that and they still werent showing up. I still dont know what to do because my friend has the same setup as i do and his is working right....maybe a windows 7 problem?

Heres a little update....what i did was i went into afcad and i took out 3 parking spots for the C-130s and checked to see if some a transit aircraft would park there and it turns out that Transit aircraft do park in those spots. So i don't think its an afcad or a scenery problem it sounds like it might be a problem with the C-130 its self.

Ive seen this problem with a package I am producing at present, my T34 would appear in the parking spots go nose up and sink into the floor within 2 seconds of start up. It turned out to be a incomplete aircraft.cfg. You may want to try replacing the aircraft.cfg with one from the same model type. Obviously you need to copy across your Fltsim entries.




Hope this helps

Mark

I thnk Mark is correct, it is far more likely to be an aircraft.cfg problem.

Download the correct model from Henry's site http://htai-models.com/downloads.html

From the aircraft.cfg copy all but the fltsim.x entries and replace the all the other non fltsim.x entries in your aircraft.cfg. Backup your aircraft.cfg before you start.

Hey guys thanks so much of the help. I got it working right!!