I've been working on an AFCAD for Balad AB in Iraq. It's quite complex with drive-thru parking, new cargo and heli aprons and stuff.
I've made FP's for the MAIW Shaw and SC ANG F-16's to bring life to this base. Only: the AC disappear after landing. I am aware of the most obvious reasons for that, like too less parking spots, radius, and so on, but as far as I can see all is ok. As a matter of fact I'm sure of that. All spots are connected, no missing hold short nodes, etc.
I needed to stop testing this morning because I had to go to work, but I can't get this out of my mind

Last things I checked:
- Airport reference point is same as original
- Airport ID is same as original
Only: I changed City and Airport Name. Could this be the problem because of the AC landing on the wrong/original runway that has no taxiway connections?
Ah.. I hate this

David