Page 1 of 1

Question for Mike JG

Posted: 03 Feb 2011, 03:57
by hawkeye52
Thank you for your excellent tutorial on modifying stock airports; it is EXACTLY what I need!

I have a problem which I hope has a simple solution: I cannot get SBuilder to link (interact) with FS9.

I have FSUIPC installed in Modules [AFCAD links perfectly with FS9]. I tried all SBuilder's tabs, options, etc. but the + will not move.

Any suggestions?

- h52

Re: Question for Mike JG

Posted: 03 Feb 2011, 04:27
by MIKE JG
While you are trying this, you have FS9 running correct? Also you have the option "Show Aircraft" checked on under the "View" pull down menu?

Know that the "+" will not move in Sbuilder unless you are moving or slewing in FS9 at the same time. You cannot physically move the "+" in Sbuilder, you have to move your FS9 position.

Re: Question for Mike JG

Posted: 03 Feb 2011, 04:38
by hawkeye52
Thanks for replying, Mike.

I should have been clearer, but the answer to ALL your questions is YES. As I slew the a/c in FS9 (top-down view) the + in SB does not move.

- h52

Re: Question for Mike JG

Posted: 03 Feb 2011, 08:25
by Firebird
I seem to remember that I had the same thing. What you have to do is zoom in, a lot, as the cross is moving but you are so far out from it that it looks stationary.

Try that. It confused me for a bit.

Re: Question for Mike JG

Posted: 03 Feb 2011, 17:22
by hawk_sh
The + always stays centered on the screen, but the field of view moves.